Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterHorizontal Roller & Sliding Windows in Pompano Beach, FL | TruePane Windows & Doors
Horizontal roller and sliding windows are a signature profile in South Florida homes, and for good reason. They open wide for coastal breezes, they’re simple to operate, and when built as impact units, they hold the line during hurricane season. At TruePane Windows & Doors, we supply and install these windows across Pompano Beach, working with PGT, CGI, CWS, ES Windows, ECO, and Mr-Glass product lines. If you’re comparing impact windows for a Pompano Beach home, condo, or rental property, this page covers the product from frame to finish. Call (863) 591-8673 to schedule a free on-site measurement and quote.
Product Overview - Horizontal Roller & Sliding Windows
Horizontal roller and sliding windows are the workhorses of Florida impact glazing. The profile glides side to side on a reinforced track rather than cranking or lifting, which makes it a natural fit for wide openings, bedrooms, living rooms, and anywhere you want maximum glass with minimal hardware. This is our workhorse impact profile: laminated impact glass tested to withstand 140-mph winds and 9,500 lbs of wind-borne debris impact, gliding horizontally on a reinforced track. In Pompano Beach, where the Atlantic is minutes away and wind zones climb quickly near the coast, that impact rating is not a bonus, it’s the baseline.
The engineering behind this product comes down to the glass package and the frame. The laminated glass uses a PVB interlayer that holds the pane together even if it’s struck. The frames, offered in aluminum or vinyl, are reinforced at the sashes and locking points. The track itself is built to stay true under cyclic pressure, which is exactly what a hurricane throws at a window: repeated, pulsing wind loads rather than one single gust. It’s a window designed for Florida’s worst weather and everyday use at the same time.
Technical Specifications
- Frame materials: Aluminum, Vinyl
- Track configurations: 2-Track, 3-Track
- Glass options: Laminated Impact Glass (PVB Interlayer), Low-E Insulated Glass, Tinted Glass, Clear Glass
- Finish options: White, Almond, Bronze, Black, Tan
- Screen options: Retractable Screen, Sliding Screen
- Compliance: Miami-Dade NOA and Florida Product Approval numbers available per configuration; engineered to Florida Building Code (FBC) High-Velocity Hurricane Zone (HVHZ) requirements
- Design pressure: Design pressures matched to your wind zone, up to +/-100 - never higher
Sizes are configured per opening. A 2-track unit gives you one fixed panel and one sliding panel. A 3-track gives you three panels across the opening, which means more ventilation and more glass. Both work well in Pompano Beach homes, but the right choice depends on your wall opening and how much airflow you want. We’ll walk through that on your measurement visit.
Hurricane & Compliance Performance
Laminated Impact Glass - The glass uses a PVB (polyvinyl butyral) interlayer that holds the glass in the frame under impact. The outer pane may crack, but the interlayer keeps the window sealed, which keeps wind, pressure, and debris out of the home.
Miami-Dade NOA / FL Product Approval - Miami-Dade NOA (Notice of Acceptance) and Florida Product Approval numbers are issued per configuration. Each size, glass package, and frame combination carries its own number, and the number is verified on your specific quote before any permit submittal.
FBC/HVHZ Compliance - The Horizontal Roller & Sliding Window profile is engineered to Florida Building Code (FBC) High-Velocity Hurricane Zone (HVHZ) requirements. HVHZ is the strictest wind standard in the state, and it applies to Pompano Beach and most of Broward County.
TAS 201 / 202 / 203 Testing - The HVHZ protocol family these units are tested under includes TAS 201 for large-missile impact, TAS 202 for cyclic wind-pressure loading, and TAS 203 for forced-entry resistance. Together they simulate what a real storm does to a window: impacts, repeated pressure cycles, and debris trying to force its way through.
Design Pressure for Your Wind Zone - Design pressures are matched to your wind zone, up to +/-100, never higher. We don’t upsell ratings you don’t need. Your specific address, exposure category, and building height determine the right number, and we verify that before you buy.
Energy Performance - Low-E and insulated glass options are available on this profile for the energy performance side of the equation. Low-E helps reflect solar heat while still letting in daylight, which matters in a Pompano Beach summer. It pairs cleanly with the impact laminate for a window that works year-round, not just in storm season.
Color & Glass Options
Finish options for the Horizontal Roller & Sliding profile come in White, Almond, Bronze, Black, and Tan. In Pompano Beach, White and Almond remain the most common on coastal condos and mid-century homes, while Black and Bronze show up more on modern builds and renovated properties. Tan works well on homes with earth-tone stucco or barrel tile roofs. If your HOA or condo board has a finish requirement, one of these five will typically match it.
Glass choice depends on what the room needs. Clear laminated impact glass gives you the truest light and is the standard choice for most openings. Tinted glass knocks down glare and heat gain on east and west-facing windows. Low-E insulated glass is the pick when a room bakes in the afternoon sun and you want to cut solar heat without heavy tinting. We’ll recommend a glass package room by room, not a one-size-fits-all default.
Installation by TruePane Windows & Doors in Pompano Beach
The best impact window underperforms badly if it’s installed wrong. That’s not a sales line, it’s the reality of HVHZ-rated glazing. The NOA rating covers the product as tested. The moment the frame is set out of square, shimmed incorrectly, or sealed with the wrong material, the rated system stops behaving like a rated system. In Pompano Beach, where wind-driven rain and coastal moisture are constant, that gap becomes an expensive lesson.
Our installation practice follows AAMA 2400/2410 standards. Every opening starts with a pre-install inspection to check the rough opening, existing flashing, and sill condition. The frame is set level, plumb, and square before fasteners go in. The perimeter is sealed with AAMA 812 low-expansion foam, which fills the gap without bowing the frame. Then we run a final water test, clean up, and verify that the permit paperwork matches the installed product. Pompano Beach sits in an HVHZ jurisdiction, and we’re familiar with the specific submittal and inspection process here. If your permit requires a Miami-Dade NOA or Florida Product Approval number on the drawings, we handle that as part of the project. You don’t chase numbers.
Frequently Asked Questions - Horizontal Roller & Sliding Windows
The Horizontal Roller & Sliding Window is rated with design pressures matched to your wind zone, up to +/-100, never higher. Your specific rating depends on the size, glass package, frame material, and the wind zone of your Pompano Beach address. We verify the correct design pressure for your opening before quoting, so you’re not paying for a higher rating than your structure requires. Call (863) 591-8673 for a site-specific evaluation.
Lead times vary by manufacturer and glass package. Standard configurations from PGT, CGI, CWS, ES Windows, ECO, and Mr-Glass typically run several weeks from order to delivery, with custom sizes and certain Low-E or tinted glass packages adding time. We confirm current lead times when we quote, and we coordinate the installation date around delivery rather than promising a start date and leaving your openings exposed. Call (863) 591-8673 and we’ll check the current schedule for your configuration.
Yes, in most Pompano Beach permit applications, the specific NOA or Florida Product Approval number for your exact configuration must appear on the permit documents. These numbers are issued per configuration, and the correct one is pulled for your specific size, frame, and glass package. We include the correct number on your quote and handle the submittal paperwork as part of the installation project. Call (863) 591-8673 to start a permit-ready quote.
Yes, within the limits of the NOA and Florida Product Approval for the configuration. Each approved configuration covers a range of sizes and track layouts, including 2-track and 3-track options. If your opening falls outside the approved range, we’ll tell you before you order, not during installation. Custom sizes are common on older Pompano Beach homes where openings were framed to non-standard dimensions. We measure, verify against the approval documents, and quote accordingly.
Keep the bottom track clear of sand, salt, and debris. In Pompano Beach, salt air and beach sand are the two biggest enemies of sliding hardware. A quick vacuum or wipe of the track every month, plus a light silicone spray on the rollers when they feel stiff, keeps the panels gliding. Avoid petroleum-based lubricants, which gum up and collect grit. The frame itself needs nothing beyond normal cleaning with mild soap and water. Do not pressure-wash the glass or frame at close range; the seals don’t need that kind of force.
Get a Quote - Horizontal Roller & Sliding Windows in Pompano Beach
If you’re ready to price Horizontal Roller & Sliding impact windows for your Pompano Beach home, the next step is a free on-site measurement. We’ll measure each opening, verify your wind zone and design pressure, confirm the right glass and finish, and give you a written line-item quote. No pressure, no change orders. Call (863) 591-8673 to schedule your free estimate with TruePane Windows & Doors.
Written by the team at TruePane Windows & Doors, serving Pompano Beach, FL and surrounding Broward County communities.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.
Other TruePane Windows & Doors Services
What Neighbors Say About TruePane Windows & Doors
Detailed Images
