Simonton Sliding & Patio Doors Nationwide | TruePane Windows & Doors

Simonton Sliding & Patio Doors: The Pompano Beach Owner's Guide

We stock and install Simonton-compatible sliding and patio door parts across Pompano Beach, with most roller, handle, and lock replacements running $140 to $380 installed depending on the hardware series and whether the track needs work. Most single-panel roller swaps are done in one visit, and if the part is on our truck we can have it in the same day you call. The way most Pompano Beach homeowners find us is the same story: a door that used to glide starts dragging, the handle stops catching, or the latch won't hold when the afternoon storms roll through.

Call (863) 591-8673

Salt air and sand are not kind to sliding door hardware. We see it every week between Lighthouse Point and the beachside condos off A1A: rollers that grind down to the metal core, tracks that collect twenty years of grit, and handles that lose their spring after a few thousand open-and-close cycles. If the door still locks but fights you every time you open it, you're not imagining it. It's the hardware telling you it's done.

Key Takeaways

• Common fixes in Pompano Beach: roller replacements, handle/lock sets, track cleaning and realignment, weatherstripping replacement.
• Typical installed cost: $140 to $380 for most single-part replacements; full hardware overhauls run higher.
• What we stock: Simonton-compatible rollers, handles, locks, and weatherstripping for the most common series on the truck.
• TruePane is an independent service provider. We are not affiliated with Simonton, and we source both OEM and quality aftermarket parts based on what serves the door best.
• We're local. Dale Kessler grew up in the Pompano Beach Highlands. We answer the phone and we show up.

Which Simonton Models This Applies To

Simonton has produced several sliding and patio door lines over the years, and the hardware compatibility is not as forgiving as most homeowners assume. The parts that fit a Reflections 5500 door are not interchangeable with the 6500 or the older ProFinish lines. The stationarity of the panel matters too: a roller assembly for a stationary panel is not the same as one for the active panel, and the wrong roller will bind or sit too high in the track.

Here's what to check before you call us. Look at the corner of the glass, the lock stile, or the bottom rail for a small etched or printed sticker. You're looking for a series number: 5500, 6500, 9800, ProFinish, or StormBreaker. If the sticker is gone, measure the thickness of the door panel and take a photo of the roller housing from underneath. We match by impression: the width of the track groove, the roller diameter, and the screw pattern. When you call, having a photo of the sticker or the roller housing saves a trip. If we can't confirm the series before we arrive, we bring the three most common Simonton roller assemblies on the truck and match on site.

One more thing worth knowing before you buy. For Simonton doors specifically, some aftermarket rollers are actually an upgrade over the OEM. The originals often shipped with plastic wheel housings that crack in heat, and a homeowner near Cypress Bend will get more life out of a stainless or brass replacement. We keep both OEM and quality aftermarket on hand and will tell you straight which one we'd put in our own house.

Signs Your Simonton Sliding & Patio Doors Is Failing

• The door drags or scrapes when you slide it. This is almost always a roller problem. The wheel has worn flat, the bearing has seized, or the track is so packed with sand and salt residue that the roller is grinding instead of rolling. Ignoring it damages the track, and a scored track is a bigger repair.
• The handle feels loose, or the latch won't catch. Simonton handles use an internal spring and pawl mechanism that wears out. When the spring fails, the handle flops and the latch won't stay engaged. A door that won't latch is a security issue, not just a nuisance.
• The door is harder to open in summer than winter. Aluminum frames expand in Florida heat, and if the rollers are set too high or the track is slightly out of level, the clearance disappears in August. This is a track alignment and roller height adjustment, not just a lube job.
• You hear a grinding or clicking sound when the door moves. That's a bearing that's failed or a roller that's shattered inside the housing. The door will still move, but every cycle is doing damage to the track rail.
• Water is getting in at the bottom corners during storms. The weatherstripping and sweep at the bottom of a Simonton patio door are replaceable wear parts, and in Pompano Beach they take a beating from sun and salt. A dried-out sweep lets water run straight onto your tile or carpet during a summer squall.

Replacement Cost & What's Included

In Pompano Beach, a single-panel roller replacement on a Simonton sliding door typically runs $140 to $240 installed, including the parts and the labor to lift the panel, remove the old rollers, clean the track, and reset the door. A handle and lock set replacement runs $95 to $185 installed. Full track replacement or realignment is a bigger job and runs $200 to $380 depending on how much of the track has to come out and whether the framing needs shimming.

What drives the range is mostly the age of the door and the series. Older ProFinish doors often have corroded screw seats that take longer to work around. Doors right on the water, from the condos along South Ocean Boulevard to the houses in Harbor Village, always have more corrosion at the hardware points. Every quote we give is a written line-item price before we start. Parts and labor are listed separately, and the price we write down is the price you pay. No change orders, no surprises. The work is covered by our Done Right Promise, and if a part fails because it was installed wrong, we come back and make it right. If it isn't in writing, it isn't a warranty.

DIY or Call Us?

You can safely do a few things before you call. Clean the track with a dry brush and a vacuum to remove sand and shell grit. Check that the weep holes at the bottom of the frame are clear. And you can note whether the door scrapes only in one spot, which tells us a lot on the phone. What we don't recommend is removing the sliding panel yourself to swap rollers. A full Simonton glass panel weighs between 80 and 200 pounds, and if it tips off the track and lands on a tile floor, you're not fixing the door, you're replacing glass and possibly the track too. The lift-and-tilt removal takes two sets of hands who have done it before, and setting the roller height so the door sits true requires feel, not guesswork. That's the kind of thing worth calling us for. (863) 591-8673. We answer the phone, and we'll give you an honest read before we ever send a truck.

FAQs

Call TruePane Windows & Doors

If your Simonton sliding or patio door is dragging, rattling, or won't latch in Pompano Beach, call TruePane Windows & Doors at (863) 591-8673 for a free estimate. Dale Kessler grew up in the Pompano Beach Highlands and has spent two decades watching what salt air does to poorly sealed and badly hung doors. We measure twice, quote on paper, and stand behind the work. A square deal, done right the first time.

Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Pompano Beach and nearby areas.