Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterCWS Roof Replacement & Installation in Pompano Beach: What to Know First
CWS roof replacement in Pompano Beach typically runs $900-$1,800 for a full glass panel replacement on a patio roof or sunroom, depending on the series, the size of the lites, and whether the frame is still square. Most CWS jobs take us one to two working days once the glass arrives, and we will always give you a written line-item price before you agree to anything. We are an independent CWS service provider, not a franchise or a manufacturer call center, and we answer our own phone when you call (863) 591-8673.
This page is for homeowners in Pompano Beach who already own CWS roof panels or a CWS glass roof system and need the roof replaced or reinstalled the right way, by a crew that understands how this brand handles salt air, standing water, and the kind of afternoon storms that roll through Broward County without much warning. If you have a CWS roof that leaks, sweats, rattles, or has a cracked panel, the information below is for you.
How CWS Products Fail - and How We Fix Them
We have worked on enough CWS roofs across Pompano Beach to know where they fail and why. Here are the five failure patterns we see most often, and what we do about each one.
- CWS Series 400 patio roof panels delaminate at the weep edge. The Series 400 flat-lite panel is a common sight on Pompano Beach patios built in the 1990s and early 2000s. The panel seal starts to separate along the low edge where condensate drains, and once that seal goes, the panel fogs from the inside out and starts holding water between the glass. Replacement is the correct fix, because re-sealing a failed lite never lasts in this climate. We order the replacement panel to the original spec and set it with new setting blocks and weep baffles.
- Aluminum CWS frame rails corrode at the screw line. Pompano Beach sits close enough to the ocean that the salt air works on powder-coated aluminum faster than it does a few miles inland. CWS frames from the pre-2005 era tend to corrode at the fastener locations, where the factory coating was broken during install. We strip the affected rail, sand it to clean metal, re-coat with a marine-grade primer, and set the new panel on isolated gaskets so metal does not sit directly against metal.
- Series 600 sloped glass roofs leak at the ridge cap. This is one of the most common CWS-specific failures we see in Pompano Beach. The Series 600 ridge cap was originally set with a rubber gasket that hardens after ten to fifteen years in South Florida heat. Once that gasket shrinks, rainwater runs under the cap and down the inside face of the glass. The owner sees water inside, assumes the panel is cracked, and sometimes pays for a replacement that was never the problem. We find this often enough that we check the ridge condition before we ever order a new panel. Fixing the gasket is a fraction of the cost of a new roof section.
- Condensation between CWS lites in afternoon rain. This is not a leak in the classic sense. It is the panel seal failing, and the humidity inside the home condensing against the cooler inner glass during a rain. Pompano Beach humidity makes this worse than almost anywhere in the continental U.S. If you can see moisture between the glass panels that you cannot wipe away, the seal is gone. The only correct repair is replacing the lite. We have done enough of these to know that replacing just one panel in a multi-panel roof can look slightly different from the old one, so we measure all panels in the run and tell you up front if a color or tint match issue is likely.
- Thermal stress cracks in CWS tempered roof panels. CWS roof lites are tempered glass, and tempered glass occasionally fails from thermal stress, especially when part of the panel sits in Pompano Beach sun and part sits in shade for long stretches of the day. The crack typically starts at a corner and spreads as a slow web. It is not a material defect, and it is not something any shop can repair in place. We replace the panel, and we set the new lite with slightly more clearance in the frame pocket to reduce the stress that caused the original break.
Our CWS Roof Replacement & Installation Process
Every CWS roof job follows the same sequence. It keeps us honest and keeps you informed.
- 1
Phone call and measurements. You describe the problem, we ask for the dimensions of the affected panels and any series markings on the frame, and we schedule a visit.
- 2
On-site diagnostic. A uniformed technician comes out, checks the frame, the ridge cap, the gaskets, and the panels themselves. We measure twice. If we find a cheaper fix that will hold, like a ridge gasket replacement, we tell you before we recommend a panel replacement.
- 3
Written line-item quote. You get the price on paper, itemized, before you authorize any work. OEM CWS glass is priced side by side with a quality aftermarket equivalent if one is available and we trust it. You decide; we list the trade-offs in plain language.
- 4
Panel removal and frame prep. We remove the failed panel, clean out the old setting blocks and sealant, treat any corrosion, and prep the opening.
- 5
New panel set and finish. The new lite is set, gasketed, sealed, and tested with water to confirm the weep system drains the way it was designed to.
- 6
Walkthrough and the Done Right Promise. Your technician walks the roof with you, points out what was done and why, and makes a note of anything that might need attention down the line. Then you get the warranty paperwork in writing, not a promise over a handshake.
What CWS Roof Replacement & Installation Costs in Pompano Beach
Here is what we typically see on CWS roof replacements in the Pompano Beach area. These are honest ranges, not teaser numbers.
| Job | Typical Cost Range |
|---|---|
| Single flat-lite CWS Series 400 panel replacement (standard size) | $900-$1,300 |
| Single sloped CWS Series 600 panel replacement | $1,100-$1,600 |
| Full patio roof panel replacement, 3-4 lites | $3,200-$4,800 |
| Ridge cap gasket repair (diagnosed before panel replacement) | $350-$600 |
| Frame prep, corrosion treatment, and re-seal | $250-$500 added to panel cost |
What moves the price: panel size beyond roughly four feet by four feet, whether the frame needs rail replacement, how high the roof is, and whether you choose OEM CWS glass or a quality aftermarket equivalent. Nothing changes on the bill after the quote is accepted. The work is covered by our Done Right Promise, and both warranty layers are registered in writing before our truck leaves your driveway. Call (863) 591-8673 for a free estimate on your CWS roof.
Why Pompano Beach Homeowners Call TruePane Windows & Doors for CWS Work
Dale Kessler grew up in the Pompano Beach Highlands and spent enough summers watching salt air eat through poorly sealed frames to know what bad glazing work costs a homeowner over the long run. That background is why we run a CWS roof replacement the way we do: we measure twice, we quote on paper, and we do not leave until the job is done right. Our Done Right Promise is not a marketing concept. If it is not right, we come back and make it right, without paperwork fights or fine print. We answer the phone with a live person, 24 hours a day, which matters when you find water on your patio ceiling at 9 p.m. And if your CWS roof is beyond a workable repair, we are also an authorized installer for PGT, CGI, ES Windows, and ECO Window Systems, so we can quote a full replacement roof system that holds up to Pompano Beach weather. Homeowners who have been burned once tend to like a company that will still be here in thirty years. That is the plan.
FAQs
Most CWS roof systems carry a limited manufacturer warranty, but the fine print often excludes seal failure after a set number of years, and it almost always excludes damage from salt air corrosion and thermal stress. We are an independent CWS service provider, so we cannot make warranty decisions for the manufacturer, but we can tell you honestly whether a workmanship issue is worth pursuing with CWS directly.
No, not in a way that will hold in Pompano Beach. Once a CWS lite seal fails and moisture is between the glass, the panel is done. Re-sealing the edge might stop the visible leak for a few months, but the fogged glass comes back. We replace failed panels with new lites and set them properly.
Once the replacement glass arrives, most single-panel CWS replacements are finished in one working day. A multi-panel roof might take two days, mostly because we let each panel set and cure before we move on to the next. You will have a firm timeline on your written quote.
We can order OEM CWS glass when it is available and when the lead time works for you. We also work with a quality aftermarket supplier when the OEM panel is discontinued or on a long backorder. We price both options side by side on paper so you see exactly what you are buying, and we only offer an aftermarket panel we would put on our own roof in Pompano Beach.
We measure every panel in the run and check the original glass specification before ordering, so the tint and thickness match more often than not. The one honest exception is older CWS glass that has UV-faded slightly over the years. A brand new lite can look a touch brighter than the panels next to it. We will tell you if that is likely before you spend a dollar, and we can replace the full run if you want a perfect visual match.
Most single-panel replacements do not require a permit in Pompano Beach, but structural roof work and full system replacements often do. We pull the permit when it is required, we schedule the inspection, and we do not call the job done until it passes. If a permit is part of your quote, the cost is on the written estimate from the start.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Pompano Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.